Me Inc NumaLink-3.0 - Manual (Page 13)

NumaLink-3.0™ Users Guide and Service Manual
Page 12 of 33
Config. File
Full path for the NumaLink-3.0 configuration file. The configuration file is
the repository of all information provided on the Translations tab (section
Error! Reference source not found.). This file is best left under control of
the NumaLink-3.0 GUI; in some circumstances, you may need to modify it
manually to access features that are not yet supported by the GUI (see
section 7).
Cache age limit (days)
Number of days to save cached input files (input files that have been
successfully translated).
Delay between translations
Delay in seconds between checks for translation work; applicable only if the
translator is running in background mode (see below).
Verbosity
Controls the amount of information that is placed in the NumaLink-3.0
audit log. Three settings are available:
• Verbose – logs a large number of informational messages, as well as
any error messages; recommended only for analyzing problems, as the
log grows quickly in this setting.
• Normal – logs a small number of information messages as well as any
error messages; recommended setting for most cases.
• Quiet – logs only error messages; results in minimum log growth
Start translator in
[background | manual]
mode
Determines the mode of operation of the translator:
• background – The translator loops indefinitely, periodically checking
for translation work.
• manual – the translator checks once for translation work and then exits
(typically used while analyzing problems).
Automatically save
changes
Save any configuration changes automatically on exit.
Automatically start
translator
Start the translator automatically when the GUI is started.
Save Save general configuration settings now.
Discard Discard changes to general settings; reverts to previous settings.
Start Translator
Start the Translator. General configuration, and the configuration of at least
one valid translation, must be completed before the translator can be started
successfully.
Stop Translator Stop the translator.
Translator [Running |
Shutting Down | Stopped |
Error]
Indicates the current status of the translator (for more status information,
see section Error! Reference source not found.)
Exit NumaLink Stop the translator if it is running, then exit the NumaLink-3.0 GUI.
4.1.1 NumaLInk-3.0 DICOM Application Entity Information
NumaLink-3.0 uses the following DICOM Application Entity information by default:
AE Title NumaLink_3_0