beautypg.com

Assembly – Makita BJS130 User Manual

Page 5

background image

5

Switch action

1

A

B

2

009014

CAUTION:

Before inserting the battery cartridge into the tool,
always check to see that the switch trigger
actuates properly and returns to the "OFF" position
when released.

When not operating the tool, depress the trigger
lock-button from B side to lock the switch trigger in
the OFF position.

To prevent the switch trigger from accidentally pulled,
the trigger lock-button is provided.
To start the tool, depress the trigger lock-button from A
side and pull the switch trigger.
Release the switch trigger to stop. After use, always
press in the trigger lock-button from B side.

ASSEMBLY

CAUTION:

Always be sure that the tool is switched off and the
battery cartridge is removed before adjusting or
checking function on the tool.

Replacement of blades

CAUTION:

Never remove the blades with bare hands. Wear
gloves. Otherwise it can cause injury.

Removing cutting head
Use the hex wrench to loosen the three screws which
secure the cutting head. Pull the cutting head straight
out to remove it with turning it left and right alternately.

1

2

3

009017


Removing shear blades

1

2

3

4

5

009019


Remove the three screws which hold the cutting head.
When removing the second screw, be careful not to fall
the sleeve. Then the blades can be removed easily.
When removing the blades, hold the blades and the
sleeve so that they do not fall from the cutting head.
Installing shear blades

1

2

3

4

5

6

004690


Install the sleeve and tighten the three screws after
inserting the center blade, side blade L & R into the
cutting head. In this process, the screw heads should be
protruding 2 - 3 mm from the cutting head surface.
If you will tighten the screws excessively, the cutting
head cannot be installed to the tool.
Installing cutting head

CAUTION:

Secure the cutting head firmly. Otherwise it can
rotate during operation and can cause serious
injury.

1

2

3

4

009016


Insert the cutting head into the tool with turning it left and
right alternately. Then tighten the three screws with the
hex wrench.

1. Cutting head
2. Screws
3. Hex wrench
4. Tighten

1. Cutting head
2. Sleeve
3. Side blade R
4. Center blade
5. Side blade L
6. Screws

1. Screws
2. Side blade L
3. Center blade
4. Side blade R
5. Sleeve

1. Cutting head
2. Screws
3. Hex wrench

1. Trigger-lock

button

2. Switch trigger