Maytag MDE9601 - Manual (Page 17)

17
Installation
Positioning the tumble dryer
The tumble dryer can be positioned as
freestanding or in a stack. Remember that
the tumble dryer produces heat and should
therefore not be located in a room that is
too small. If the room is very small, drying
will take longer due to the limited quantity of
air.
Caution!
The machine must not be installed behind a
lockable door, a sliding door or a door with
hinges on the opposite side to those of the
tumble dryer.
Advice!
To improve ventilation, leave the door to
the room where the tumble dryer is located
open.
Caution!
Any electrical installation must be carried
out by authorised professionals.
A. Freestanding
The tumble dryer can be positioned beside
the washing machine.
B. Stacking
The tumble dryer can be placed on top of
an Asko washing machine. In this case you
use the stacking attachments that come
with the machine:
2 foot cups. These can be found in a bag in
the drum.
2 anti-tilt devices. These come attached to
the bottom left corner on the back of the
machine.
Extending plates can be ordered from your
local retailer.
How to fit the stacker:
1. Undo the two screws indicated on the
back of the washing machine.
2. Secure the anti-tilt device using the
screws as shown in the picture.
3. Attach the plastic cups that will hold the
tumble dryer’s front feet to the washing ma-
chine’s top cover. This is essential, as once
the tumble dryer’s feet are resting in the
plastic cups you know the dryer is correctly
positioned on the washing machine.