Marantz CC4001 - Manual (Page 7)

4
ENGLISH
7
Cautions on handling power cord
• Do not touch the power cord with wet hands.
• When disconnecting the power cord, always
make sure that you take hold of the plug.
Yanking out or bending the cord can damage it
and/or cause electric shocks or a fire.
• Get into the habit of disconnecting the power
plug before leaving home.
7
Do not attempt repairs yourself
• Refrain from lubricating the player: doing so
can cause malfunctioning.
• Only qualified engineers with specialized
expertise are authorized to repair the pick-up
and parts inside the player.
PRECAUTIONS
• In winter, droplets of water form on the insides
of the windows of a heated room: this is called
condensation. This player uses an optical
lens, so the condensation may form in the
following cases.
- In a room immediately after the heating has
been turned on
- In a room where the humidity level is high
- When the player has been suddenly brought
from a cold location into a warm room
Since, in cases like this, the track numbers
may not be read and the player is prevented
from operating properly, wait about 30 minutes,
and then operate the player.
• This player may cause interference on a tuner
or TV set. If this is the case, place it further
away from the tuner or TV set.
• Compact discs have much less noise than
analog records and hardly any noise is heard
before play starts. Bear in mind, therefore, that
if the volume control on the amplifier is set too
high, you will risk damaging other audio
components.
• Do not use commercially available lens
cleaners, as they may damage the lens.
USING REMOTE CONTROL UNIT
7
Cautions on handling batteries
Misuse of the batteries can result in electrolyte
leakage, rupturing, corrosion, etc.
Bear in mind the following points when using
batteries.
• Remove the batteries from the remote control
unit if the unit is not going to be used for a
prolonged period (a month or more).
• Do not use an old battery together with a new
one.
• Insert the batteries while ensuring that their ª
and · poles are properly aligned with the
corresponding markings on the remote control
unit.
• Batteries with the same shape may have
different voltages. Do not use different types
of batteries together.
• If electrolyte has leaked, thoroughly wipe the
inside of the battery compartment, and then
insert new batteries.
• When batteries which are no longer required
are to be discarded, follow the directions
(regulations) laid down by the local authorities
in the area concerned for their disposal.
LOADING BATTERIES
Batteries in this remote control unit have a life of
approximately 1 year under normal operating
conditions. If the remote control unit is not going to
be used for an extended period of time, remove the
batteries. Also, if you notice that the batteries are
starting to run down, replace them as soon as
possible.
q Remove the battery cover.
w Insert the batteries with correct ª / ·
orientation.
e Close the battery cover until it clicks shut.
Two AA-size batteries
7
Remote control
Operate the remote control unit (RC4001CC)
within a distance of approx. 5 m from the infrared
signal reception window (remote sensor) on the
front of the CD Changer.
Remote control operation may not be possible if
the remote control unit’s transmitter is not pointing
in the direction of the remote sensor or if there is
an obstruction between the transmitter and the
remote sensor.
Remote control operating range
5 D IS C C D C HA NG ER C C4 00 1 POW ER O N/S TAN DB Y ST ANDB Y
O PE N/C LO SE RE PE AT
LE VE L
PH ON ES
RA NDO M PLA Y ST O P PA USE
DIS C S KIP
1 2 3 4 5
Approx.
16.4 ft. (5m)
Remote control unit (RC4001CC)