Marantz CC4001 - Manual (Page 10)

7
ENGLISH
NAMES AND FUNCTIONS
REMOTE CONTROL ANALOG OUT ANALOG OUT
OPTICAL COAXIAL
DIGITAL OUT
R
L
OUT
IN
INT. EXT.
AC IN
FLASHER IN
MODEL NO. CC4001 MODEL NO. CC4001
RS-232C
A B H C D E F G
REAR PANEL
A EXT./INT. (External/Internal switch)
When this unit is used as a standalone
component, set this switch to the INT. side.
When it is used connected to external
component by a remote connecting cable and
to audio component with a remote sensor that
supports remote controls by Marantz, set this
switch to the EXT. side.
Caution
If the unit is used as standalone and the
switch is set to EXT. position, remote control
unit cannot be used.
B RS-232C External Control Port
A control port for professionals (custom
installers).
C REMOTE CONTROL IN/OUT (input
and output) connectors
When the remote control connectors on the
unit and on a Marantz AV component are
connected using the accessory remote
connecting cables, the components can be
operated as a system by remote control.
• When connecting to a component which is
equipped with remote control connectors,
the unit’s REMOTE CONTROL IN
connector must always be connected to
the REMOTE CONTROL OUT connector
on the other component to be connected.
• When connecting a component which is
not equipped with an infrared remote
sensor, this component must always be
connected to the unit’s REMOTE
CONTROL OUT connector.
D ANALOG OUTPUT connectors
These are the output jacks of the analog audio
signals. The supplied analog connection cord
can be connected to the CD, AUX, or other
connectors on an amplifier. Be sure to connect
the L and R channels correctly to the
corresponding jacks.
Caution
Never connect to the PHONO connector on
the amplifier.
E DIGITAL AUDIO OUT COAXIAL
This jack is to be connected with a recording
device, amplifier, D/A converter, etc that has
coaxial digital input using an optional coaxial
digital cable.
F DIGITAL AUDIO OUT OPTICAL
This jack is to be connected with a recording
device, amplifier, D/A converter, etc that has
optical digital input using an optional square
type optical digital cable.
G Flasher Input jack
A control port for professionals (custom
installers).
This is used to control the unit from other
rooms using keypad, etc.
H AC Inlet
Connect the supplied power cord to this jack
and a household AC power outlet.