Motorola RDX SERIES RDU4100 - Manual (Page 47)

PROG
RAMM
ING
FEAT
URES
English
45
• Short press the PTT button and move ahead to
program the third digit. LED Indicator will blink
red to indicate current value is ‘1’.
• Press the SB1 button to change the ‘third digit’ to
‘2’. Press the SB1 button to change again this
‘third digit’ to ‘3’. Radio will signal the chosen
value.
• Long press the PTT button to save changes and
return to 'Idle' Programming Mode.
• Once in 'Idle' Programming Mode, LED Indicator
will start blinking a green heartbeat.
• Long press the PTT button to exit Programming
Mode.
Example of Programming Auto-Scan
Auto-Scan is the last Programming Mode and
can be set to either ON or OFF on a particular
channel.
To set Auto-Scan to ON:
• Enter Programming Mode and select the desired
channel (see Figure 1: Entering Programming
Mode on page 37).
• Short press the PTT button six times to enter
Auto-Scan Programming Selection Mode. The
radio will signal beeps and will show the current
Auto-Scan setting (please refer to “Reading Auto-
scan Settings” on page 41).
• Short press the SB1 button to toggle ON/OFF the
Auto-Scan feature in the channel. When ON, the
LED Indicator will blink RED once. When OFF,
the LED Indicator will blink ORANGE once.