MITSUBISHI ELECTRIC XD250U-ST - Manual (Page 6)

EN-6
Overview
1 FOCUS ring
2 Control panel
3 Air inlet grille
4 Remote control sensor (Front)
5 Air outlet grille
6 Terminal board
7 Speaker
8 Adjustment feet
9 Lock bar
10 Lamp cover
Caution:
Do not replace the lamp immediately after using the pro-
jector because the lamp would be extremely hot and it
may cause burns.
Control panel
1 Power button
2 SOURCE button
Each press of this button enables the input source to
switch in the following order: COMPUTER 1, COM-
PUTER 2, HDMI, VIDEO, and S-VIDEO.
3 STATUS indicator
4 POWER indicator
Terminal board
1 Power jack
2 COMPUTER IN terminal (1, 2) (Mini D-SUB 15-pin)
3 MONITOR OUT terminal (Mini D-SUB 15-pin)
4 Remote control sensor (Rear)
5 AUDIO IN-1 terminal (Mini jack)
6 AUDIO IN-2 terminal (Mini jack)
7 AUDIO OUT terminal (Mini jack)
8 S-VIDEO terminal
9 VIDEO terminal
10 SERIAL (RS-232C) terminal (Mini DIN)
11 Kensington Lock
12 LAN terminal (RJ-45)
13 AUDIO IN-3 terminals (L/R)
14 HDMI terminal (HDMI 19-pin)
Kensington Lock
This projector has a Kensington Security Standard con-
nector for use with Kensington MicroSaver Security Sys-
tem.
Refer to the information that came with the Kensington
System for instructions on how to use it to secure the pro-
jector. Please contact Kensington Technology Group
below.
Kensington Technology Group
2855 Campus Drive
San Mateo, CA 94403, U.S.A.
Phone: +1- (650)572-2700 Fax: +1- (650)572-9675
10
8 7 4
1 2 3
9
6
5
3 2 1 4
7 5 13 8 2 14 3 10 12 4
6 1 9 11