Philips Magnavox VRA641AT99 - Manual (Page 42)

42 Index Search
3
When you make a recording, the VCR automatically places an
index code at the beginning of the recording. Essentially, an index
code is a type of “bookmark” for your tape. This feature is useful
if you have several different programs recorded on a single tape.
Fast forward or rewind to the next or previous index code on the
tape by following the steps below.
1
Press the VCR button.
2
Make sure the VCR is in VCR position. (The VCR light will appear
on the display panel when the VCR is in VCR position.) If the
VCR light does not appear, press the VCR/TV button
once.
4
Press the INDEX
¢ button to fast forward to the next
index code on the tape. Or, press the INDEX
4 button
to rewind to the previous index code on the tape. Wait for
the VCR to fast forward or rewind the tape. When the index
code is reached, tape playback will begin automatically.
NOTE: You may press an INDEX button repeatedly to skip over
multiple recordings. For example, if you want to fast forward past
four recordings, press the INDEX
¢ button four times. INDEX
4 will appear in the bottom right corner of the screen. The index
codes will count down on the screen as the search progresses.
(ON SCREEN MODE can not be set to OFF. Details are on page
25.)
3
Insert a tape in the VCR.
Insert a tape.
• To stop an Index Search that is in
progress, press the STOP 9 button.
• The VCR does not place an index
code at the point where a recording
is paused, then resumed.
• INDEX may flash on the screen
briefly when you begin a recording.
Helpful Hints
1
4
2
VCR TV
VCR/TV
QUICK PROGRAMMING
POWER
STILL/SLOW
EJECT
CH VOL
EXIT/STATUS
TIMER
SMARTPICTURE
SKIP SEARCH INDEX AUDIO/MUTE
MENU
- +
CBL / DBS
1 2 3
4 5 6
7 8 9
START STOP DATE
DBS DAILY
PLAY
REW FF
STOP
WEEKLY
/OTR REC REC
-
+
-
+
SPEED 0 CLEAR
.
.
.
.
.
.
.
.
.
.
.
.
.
. .
.
.
.
.
.
.
.
.
.
.
.
.. .. .. .. .. .. .. ..
/OK