MicroNet Technology SP766W - Manual (Page 19)

11
2. Hardware Installation
1. Unpack the print server package and verify that all the items listed in
the section 1.2 are provided.
2. Connect the print server to the printer you want to share on the
network.
3. Connect the print server to your network by attached the network
cable to the UTP port of the print server.
4. Connect the power adapter to the print server. The print server will
perform the Power-On-Self-Test (POST) after it is powered on. During
the POST, the three Printer Port LEDs will be on. When the LEDs are
unlighted, the print server is ready.
NOTE1: MUST use the power adapter shipped with the print server, do
NOT use any other power adapter from any sources.
NOTE2: To prevent the compatibility problem between print server and a
few printers, it is recommended that you power on the print server
before the printer.