Bit angle (when chipping, scaling or demolishing), Depth gauge – Makita HR3000C User Manual

Page 10

To remove the bit, pull the chuck cover down all the way and
pull the bit out.

Bit angle (when chipping, scaling or demolishing)

The bit can be secured at 12 different angles. To change the
bit angle, depress the lock button and rotate the change lever
so that the pointer points to the “O” symbol. Turn the bit to
the desired angle.

Depress the lock button and rotate the change lever so that
the pointer points to the

symbol. Then make sure that the

bit is securely held in place by turning it slightly.

Depth gauge

The depth gauge is convenient for drilling holes of uniform
depth. Insert the depth gauge into the hole in the grip base.
Adjust the depth gauge to the desired depth and then tighten
the clamp screw to secure the depth gauge.

NOTE:

•

The depth gauge cannot be used at the position where
the depth gauge strikes against the tool body.

1. Bit

2. Chuck cover

003167

1. Lock button

2. “O” symbol

003171

003175

1. Depth gauge

2. Clamp screw

3. Grip base

003182