Miller Electric Spectrum 1250R - Manual (Page 18)

OM-217 Page 14
3-4. Selecting A Location
1 Lift Hook
Install lift hooks using supplied
bolts. Tighten to 25 ft/lb (34 N·m).
2 Spreader Bar (Not Supplied)
3 Lifting Cable (Not Supplied)
If lifting unit, use spreader and
cable.
4 Lifting Eye
5 Lifting Forks
If using lifting forks, extend forks
beyond opposite side of unit.
6 Rating Label (Non CE Models
Only)
7 Rating Label (CE Models
Only, See Section 2-2)
Use rating label to determine input
power needs.
8 Plate Label (CE Models Only)
9 Line Disconnect Device
Locate unit near correct input pow-
er supply.
Y Special installation may be
required where gasoline or
volatile liquids are present –
see NEC Article 511 or CEC
Section 20.
4
5
Movement
S-0439 / Ref. ST-800 402-B / ST-159 463-B
9
18 in (460
mm)
Location And Airflow
OR
18 in (460
mm)
6
8
3
2
1
7