Miller Electric XR A - Manual (Page 32)

OM-1581 Page 28
5-12. Gun Controls
1 Gun Trigger
Press trigger to energize welding
power source contactor (if applica-
ble), start shielding gas flow, and
begin wire feed.
For shielding gas preflow and post-
flow, partially press trigger before
and partially release after welding.
2
Wire Speed Control
Use control to adjust wire feed
speed. The numbers around the
control are for reference only.
Ref. 151 666-E
1
2
5-13. Shielding Gas
3
1 Shielding Gas Cylinder
2 Valve
3 Gun Trigger
Open valve on cylinder just before
welding.
Gun trigger turns weld output and
gas flows on and off (see Section
5-12).
Close valve on cylinder when
finished welding.
sb5.1 6/92 − S-0621-C / Ref. 151 666-E
1
2
5-14. Coolant Supply For Water-Cooled Models Only
1 Coolant Supply
See Section 4-16 for coolant
guidelines.
Turn On coolant supply before
welding.
Turn Off coolant supply when
finished welding.
Ref. 150 755-A
1
5-15. Sequence Of Gas Metal Arc Welding (GMAW) − Continuous Or Spot
Begin Welding
ssb6.1* 9/92
Install &
Connect
Equipment
Put On
Personal Safety
Equipment
Set Controls
Turn On Gas
And Water (If
Applicable)
Turn On Feeder
And Welding
Power Source