Miele NOVOTRONIC T 7644 C - Manual (Page 25)

Cleaning with water
The lint screens and door lint filter
should be given a wet cleaning only
when severely blocked or plugged.
^ Open the door and extract the door
lint filter from the door casing.
Remove both lint screens from the
port-hole:
^ Turn the left and right lint screen
knobs
a (until you hear them click).
^ Grasping the knobs, pull the lint
screens out towards the centre
b.
^ Clean all screens under running hot
water.
^ Shake the screens thoroughly until
drips are no longer visible.
^ Dry them thoroughly and with care.
^ Also clean the air passages
underneath the screens, using a
vacuum cleaner, for example.
,
When inserted, all lint screens
must be dry. Wet screens can cause
faulty dryer operation!
^ Insert the door lint filter fully into the
door casing.
^ Insert the lint screens in the port-hole
and push them downwards.
^ Latch both knobs (until you hear
them click).
Cleaning the dryer
Disconnect the dryer from the
electrical supply.
^ Clean the housing, control panel and
door seal only with a slightly damp
cloth and mild detergent or soapy
water.
^ Clean stainless steel parts (like the
drum) with a suitable stainless steel
cleaner.
Use no scouring products, cleaners
containing solvents, or glass or
all-purpose cleaners. They can
damage plastic surfaces and other
parts.
^ Dry all parts with a soft cloth.
Cleaning and care
25