MITSUBISHI ELECTRIC WS-65315 - Manual (Page 53)

52 53
ADVANCED FEATURES Menu: CONVERGENCE
CONVERGENCE Menu
(Figure 47)
Your Mitsubishi TV has three picture tubes which
need to be aligned to properly converge the
projected light beams on the screen. Each picture
tube projects a single color of red, blue or green.
During production, your TV was carefully adjusted
to properly align these colors. However, moving
the TV, the TV’s location in relation to the Earth’s
magnetic poles, and the passage of time can cause
these adjustments to change.
As a special feature, you have the ability to adjust
the red and blue light beams in reference to the
fixed green light beam. This process is called
convergence. There are two separate memories for
convergence. One, for SD 480i/480p signals; the
other for HD 1080i signals. SD convergence should
be adjusted while watching an SD source and HD
convergence should be adjusted while watching an
HD source.
The TV should be fully warmed up before adjusting
Convergence. Turn the TV On and wait at least 30
minutes before starting adjustments.
Convergence Screen
(Figure 48)
When the Red and Blue crosshairs are properly
converged, the center-screen crosshairs will appear
white. You can use , , , or to move the
Red and Blue crosshairs. Press VIDEO to switch
between Red and Blue. Press AUDIO for the
Advanced Convergence screen.
����������� ����
��� �����������
���� �����������
����� ������� ��������
���� ����
�������� �������� ����
�� ������ ������ ���� �� ������
������ �� ������
Figure 47. CONVERGENCE menu
����������� ����
�������� �������� ����
���� ����
���
����� ������ �� �������� ��� �����
����� ����� �� ������ �� ����
����� ���� �� �� ����
����� ������ �� ������ �������
����� ����� �� �������� �����������
Figure 48 . Convergence screen
����������� ����
�������� �������� ����
���� ����
��� �� ���� �����������
����� ���� ��� ���� ����� ���� ��� ����
Figure 49 . Advanced Convergence screen
A
D
VA
NC
E
D F
E
A
T
U
RE
S M
en
u
: C
ON
V
E
R
G
E
NC
E
Advanced Convergence
(Figure 49)
After adjusting the Red Convergence and Blue
Convergence, you can fine-tune your TV by
adjusting the Red and Blue convergence at 64
individual points. Move the flashing bracket to a
position needing adjustment by pressing , , ,
or .
The convergence screen will timeout if no
adjustments are made within a couple of
minutes. If the screen does timeout, your
adjustments will be saved. Pressing the
CANCEL button will reset the convergence
settings.