Connecting an antenna or wall outlet cable, Separate uhf and vhf antennas – MITSUBISHI ELECTRIC WS-65315 User Manual

Page 14

Separate UHF and VHF Antennas

(Figure 1)

1. Connect the UHF and VHF antenna leads to the

UHF/VHF combiner.

2. Push the combiner onto ANT-A on the TV back

panel.

UHF/VHF combiners are not provided with the TV. They

are available at most electronic stores.

Note: This TV will only be able to provide an

analog signal through ANT-A on the

TV back panel.

See page 5 for Outdoor Antenna Grounding

information.

��

� � ��

��

�

Figure 1. Connecting separate UHF and VHF antennas.

��

�

��

� � ��

��

Figure 2. Connecting twin lead antenna, coaxial lead

antenna, or wall outlet cable.

Twin Lead Antenna, Coaxial Lead

Antenna, or Wall Outlet Cable

(Figure 2)

For antenna with twin flat leads:

1. Connect the 300 Ohm twin leads to the

transformer.

2. Push the 75 Ohm side of the transformer onto

ANT-A on the TV back panel.

300 Ohm to 75 Ohm matching transformers are not

provided with the TV. They are available at most
electronic stores.

For cable or antenna with coaxial lead:
3. Connect the incoming cable to ANT-A on the TV

back panel.

Note: This TV will only be able to provide an

analog signal through ANT-A on the TV back

panel.

See page 5 for Outdoor Antenna Grounding

information.

Connecting an Antenna or Wall Outlet Cable

Additional connection cables are not

provided with the TV. They should be
available at most electronic stores.

Note: The TV back panel and connections shown here are for reference only and may vary by model.

ng a

n A

a o

r W

l O

et C

Mitsubishi strongly recommends against
using antennas with twin flat leads. Twin flat
lead antenna wires are subject to interference
which may adversely affect the performance
of the TV. We recommend using coaxial
antenna cable.

This manual is related to the following products:

WT-42315