Konica Minolta bizhub C300 - Manual (Page 145)

7 Transmission Applications
7-28 Network Fax
Tr
ansmission
Ap
plicat
ion
s
Chapter 7
7.11 TX Stamp
TX Stamp
When transmitting a fax via the ADF, a stamp can be affixed to the pages of
the document that have already been scanned, allowing you to confirm that
these pages have been scanned. The stamp is a pink circle (
), 4 mm in
diameter and affixed at the rear edge on the front side of the original
document. When both sides of a sheet are transmitted, the stamp is affixed
respectively on the front side.
0 Specifications
The stamp ink must be replaced when it runs out. When color of the
verification stamp becomes light, contact your service representative for
a replacement.
When mixed original mode is selected, no stamp may be affixed to the
above position.
Even though the TX Stamp function has been set, no TX Stamp is put if
the document is transmitted in the multi-feeding. In such a case, transmit
the document again.
Check if the document was correctly transmitted by the Transmission
Report or Transmit Result of the CHECK MODE.
1
Press [Fax] on the control panel to view the FAX screen, if it is not
already displayed.
2
Press [Scan Setting] and then press [Application].
Stamp position
Front surface of
original document
Original document
transmitting direction