Philips Magnavox 15MF200V/37 - Manual (Page 7)

7
A
NTENNA
C
ONNECTION
TV
1 2
DC IN ANALOG AUDIO OUT
AUDIO
TV
S-VIDEO
VIDEO
1 2
A combination antenna receives normal
broadcast channels (VHF 2–13 and
UHF 14–69). Your connection is easy
because there is only one 75
Ω (ohm)
antenna jack on the back of your TV,
and that’s where the antenna goes.
1 If your antenna has a round cable
(75 ohm) on the end, then you're ready
to connect it to the LCD TV Monitor.
If your antenna has flat, twin-lead
wire (300 ohm), you first need to
attach the antenna wires to the screws
on a 300- to 75-ohm adapter.
2 Connect the antenna (or adapter) to
the TV jack on the rear of the LCD
TV Monitor. If the end of the antenna
wire is threaded, screw it down finger
tight.
B
ASIC
C
ABLE
TV C
ONNECTION
Y our Cable TV signal into your home may
be a single, 75
Ω (ohm) cable. If so, this
connection is very simple. Follow the step
below to connect your Cable TV signal to
your new LCD TV Monitor.
1 Connect the Cable TV signal to the TV
jack on the LCD TV Monitor. Screw it
down finger tight.
TV
DC IN ANALOG AUDIO OUT
TV
S-VIDEO
VIDEO
1
AUDIO
1 2
Twin-lead
wire to
300-75Ω
adapter
Antenna
with 75Ω
cable
Rear Jack panel of
Television
Outdoor or Indoor Antenna
(Combination VHF/UHF)
Cable TV signal from
Cable Company
(75Ω coaxial cable)
Rear Jack panel of
Television
OR