Philips Magnavox 15MF200V/37 - Manual (Page 35)

No Power
• Check the TV power cord. Disconnect the power cord from the power outlet for 10 seconds, then reinsert the plug
into the outlet. Press POWER to turn on the TV again.
• Make sure the outlet is not on a wall switch.
• Make sure a fuse has not blown at the power outlet.
No Picture
• Check the antenna or Cable TV connections. Connect the antenna or Cable TV signal securely to the TV’s 75
Ω jack
on the rear of the TV.
• Set TUNER MODE correctly. Details are on page 12.
• Activate AUTO PROGRAM to find all available channels. Details are on page 13.
No Sound
• Press the VOL+ and VOL- buttons to adjust the volume.
• Press the MUTE button on the remote control to cancel or restore the volume.
• If you have connected other equipment to the TV (such as a VCR or DVD Player), make sure the audio cables are
connected securely between the TV and the other equipment.
• Check the SOUND settings. Details are on page 18 or 30.
Remote Control does not work.
• Check the batteries. If necessary, replace them with two AAA heavy duty (zinc chloride) or alkaline batteries.
• Clean the remote control as well as the remote control sensor on the front of the TV.
• Check the TV power cord. Disconnect the power cord from the power outlet for 10 seconds, then reinsert the plug
into the outlet. Press POWER to turn on the TV again.
• Make sure the outlet is not on a wall switch.
• Make sure a fuse has not blown at the power outlet.
• Always point the remote control toward the front of the TV (toward the remote sensor).
TV displays wrong channel or no channels.
• Repeat channel selection.
• Add the channel number(s) into the TV’s memory. Use STORE. Details are on page 14.
• Make sure TUNER MODE is set correctly. Details are on page 11. Then activate AUTO PROGRAM to set up all
available channels. Details are on page 12.
35