Multiquip MQ Power Whisperwatt Generator DCA-25SSI - Manual (Page 44)

PAGE 44 — DCA-25SSI — PARTS AND OPERATION MANUAL— FINAL COPY (06/29/01)
10. The generator's frequency meter (Figure 43) displays
the 60 cycle output frequency in HERTZ.
Figure 44. Voltage Meter (Volts)
11. The generator's voltage meter (Figure 44) displays the
120 VAC in VOLTS. If the voltage is not within the
specified frequency tolerance, use the voltage
adjustment control knob (Figure 45) to increase or
decrease the desired voltage.
Figure 38. Voltage Selection Switch
4. Close all engine enclosure doors (Figure 37).
Figure 37. Engine Enclosure Doors
DCA-25SSI — GENERATOR START-UP PROCEDURE
5. Check the voltage selection switch (Figure 38) is at
the desired voltage.
6. Make sure the engine throttle (Figure 39) is in
’start/idle’.
8. Once the preheat indicator lights, turn the ignition
key to ‘START’ until the engine starts (Figure 41).
Then release the key to ‘RUN’.
Figure 39. Engine Throttle Lever (low)
Figure 41. Ignition Switch ‘START’
Figure 43. Frequency Meter (Hz)
7. Turn the ignition key to preheat (Figure 40), until the
preheat indicator turns on.
Figure 40. Ignition Switch ‘PREHEAT’
9. Pull the engine throttle and turn to the right until the
metal stop rests against the control panel (Figure 42).
Figure 42. Engine Throttle Lever (high)