Metrologic Instruments StratosS MS2222 - Manual (Page 30)

26
I NSTALLATION
EAS D EACTIVATION
SW1 and SW2 are the switch banks inside the Checkpoint device that set the deactivation range. The following is a list of
Checkpoint recommended switch bank settings.
Base Model Checkpoint Recommended Switch Bank Settings
MS2221 SW1 & SW2 switches 1 and 6 set to ON
MS2222 SW1 & SW2 switches 1 and 6 set to ON
All StratosS models have a connector labeled EAS In on the bottom of the unit. Metrologic has an optional EAS cable
(
MLPN 52-52511 x) available for purchase for connection between the Checkpoint device and the StratosS.
Figure 24. EAS Cable Connection (Bottom of StratosS)
The following figure shows the location of the EAS deactivation area for the StratosS. It is important to pass the entire tag
through this area to deactivate the security tag.
Figure 25. EAS Deactivation Area