Memorex MVDP1075 - Manual (Page 9)

CHARGING THE BATTERY PACK
“LOW BATTERY” will appear on the screen when the battery is low and needs
recharging. The battery can be charged while attached or not attached to the unit
as follows:
WITH THE BATTERY ATTACHED TO THE UNIT:
With the battery pack attached, insert the small end of the AC adapter
into the DC IN CHARGE jack on the side of the battery pack or the DC IN
jack on the side of the unit. Insert the other end (with the 2 blades) into a
conveniently located AC outlet having 120V AC, 60Hz. The CHARGE indicator will
light red as the battery is charging and green when charging has completed.
Disconnect the AC adapter plugs when charging has finished.
WITH THE BATTERY NOT ATTACHED TO THE UNIT:
You can also charge the battery when it is not attached to the unit by inserting the
small end of the AC adapter into the DC IN CHARGE jack on the side of the battery
pack. Insert the other end (with the 2 blades) into a conveniently located AC outlet
having 120V AC, 60Hz. The CHARGE indicator will light red as the battery is
charging and green when charging has completed. Disconnect the AC adapter
plugs when charging has finished.
NOTE:
• Fully charge the battery pack (8 hours) before using it for the first time. After the
initial charge, it should take approximately four hours to charge.
• The battery can charge up for approximately 300 times.
• A fully-charged battery can operate for about two hours.
USING THE CAR ADAPTER
Plug the small end of the car adapter into the DC IN jack and then plug the other
end into the car cigarette lighter socket.
8
POWER SOURCES (CONTINUED)