Morphy Richards PerformAir Upright Vacuum - Manual (Page 4)

4 UK Helpline 0870 060 2604 Replacement Parts 0870 167 6635 Ireland Helpline 1800 409119
Operating the
appliance
Assembly
WARNING: Do not plug in
the cleaner until it is
assembled.
1 Carefully unpack all
components.
2 Lift cleaner body to upright
position.
3 Remove the two upper screws
that are either side of the cable
storage and remove the dust
canister.
4 Insert the handle into the main
body of the cleaner and push
down firmly before re-fitting and
tightening the screws. A.
5 Re-attach the dust canister.
IMPORTANT: The cleaner may
not operate correctly if the
canister is not securely in
position so please ensure that
the handle is correctly fitted
before attaching the canister
Using on carpets
1 Place cleaner in its upright
position.
2 Set the floor type adjustment to
the desired position using the
pedal „ B.
3 Release the mains cable by
turning the quick release cleat
Ë half a turn and extend the
cable fully.
4 Plug the cable into the mains
socket.
5 Step on the upright release
pedal ‚ to release the handle
to the desired position.
6 Press the control switch on the
handle to setting ‘II’ (carpet).
• Note: The beater bar will
automatically switch off when
the cleaner is parked upright.
IMPORTANT: To prevent damage
to carpets, never leave the
cleaner switched on in one
place for an extended period.
• Note: Never have the floor
nozzle set too low such that the
cleaner is hard to push.
Using on hard floors
Follow steps 1-5 from the
instructions for ‘Using on
carpets’
6 Press the control switch on the
handle to ‘I’ (hardfloor)
NOTE: The beater bar does not
rotate with the power switch set
to ‘I’ (hardfloor)
Nozzle height settings
Variable power
Slide the variable power switch
‹ C upwards to increase the
suction power or downward to
decrease suction. This feature is
most useful when using the
hose and accessories. Use the
minimum setting when
vacuuming delicate
fabrics/curtains etc. When not
using the hose it is advisable to
keep the variable slider set to
maximum.
Using the hose and
attachments
1 Take the hose connector out of
the storage clip.
2 Pull down the hose connector
flap Ì and insert the hose
connector with its ‘mouth’
pointing upwards D.
IMPORTANT: Push the hose
connector fully in such that the
flap Ì latches on to the È
C
B
A
1 Wood and laminate
2 Short pile carpet and vinyl
3
Medium carpet
4
Deep carpet
5 Tools
D
М
„
И
73352 rev2 22/6/06 11:09 Page 4