beautypg.com

Starting the engine, Stopping the engine, Check fuel level – MTD 08M User Manual

Page 17: 32 1 4 check oil level, Fuel recommendations

background image

17

s

ectiOn

5 — O

peratiOn

Check Fuel Level

Clean around fuel fill before removing cap to fuel.

1.

Fill tank to approximately 1-inch below lowest portion of

2.

neck to allow for fuel expansion. Be careful not to overfill.
NOTE: Before refueling, allow engine to cool 2 minutes.

Starting The Engine

WARNING:

Always keep hands and feet clear of

equipment moving parts. Do not use a pressurized

starting fluid. Vapors are flammable.

Pull out the choke knob located on the left side of the

1.

upper handle. See Fig. 10-3.

NOTE: Use of the choke may not be necessary if the engine

is warm or the air temperature is high.

2.

Standing behind the mower, depress the blade control

handle and hold it against the upper handle.

3.

Pull the starter grip lightly until resistance is felt, then pull

rapidly to overcome compression, prevent kickback, and

start engine. Repeat if necessary. See Fig. 10-3.
NOTE: Do not allow the starter grip to snap back against

the rope guide. Return it gently to prevent damage to the

starter.

4.

When engine warms up, push in the choke knob. See Fig.

10-3.

Stopping The Engine

Release the blade control.

1.

3

2

1

4

Check Oil Level

NOTE: Be sure to check the engine on a level surface with the

engine stopped.

Remove the oil filler cap and wipe the dipstick clean. See

1.

Fig. 10-2.

Insert the dipstick into the oil filler neck, but do not screw

2.

it in.
If the level is low, slowly add oil to the upper limit on the

3.

dipstick. See Fig. 10-2 inset.
Tighten dipstick firmly before starting engine.

4.

NOTE: Do not overfill. Overfilling with oil may cause

smoking, hard starting, spark plug fouling, or oil saturation

of air cleaner.

Fuel Recommendations

Use automotive gasoline (unleaded or low leaded to minimize

combustion chamber deposits) with a minimum of 87 octane.

Gasoline with up to 10% ethanol or 15% MTBE (Methyl Tertiary

Butyl Ether) can be used. Never use an oil/gasoline mixture, dirty

gasoline, or gasoline over 30 days old. Avoid getting dirt, dust, or

water in the fuel tank. DO NOT USE E85 GASOLINE.

WARNING:

Gasoline is extremely flammable and is

explosive under certain conditions. Refuel in a well-

ventilated area with the engine stopped. Do not

smoke or allow flames or sparks in the area where

the engine is refueled or where gasoline is stored.

Avoid repeated or prolonged contact with skin or

breathing of vapor.

WARNING:

Do not overfill the fuel tank (there

should be no fuel in the filler neck). After refueling,

make sure the tank cap is closed properly and

securely. Be careful not to spill fuel when refueling.

Spilled fuel or fuel vapor may ignite. If any fuel is

spilled, make sure the area is dry before starting the

engine.

Oil Fill Cap/

Dipstick

Upper Level

Figure 10-2

Figure 10-3