MITSUBISHI ELECTRIC MSH24WN - Manual (Page 9)

9
ON/OFF
FAN
TOO
WARM
TOO
COOL
VANE
MODE
STOP
START
HR.
MIN.
I FEEL COOL
DRY
AM PM
CLOCK
˚C
AMPM
WIDE VANE
LONG
HEAT
RESET CLOCK
1
2
3
4
5
COOL/
DRY
HEAT
AIR FLOW VELOCITY AND DIRECTION ADJUSTMENT
AIR FLOW velocity and direction can be selected
as required.
■
To change the AIR FLOW velocity, press
the
FAN button.
Each time the button is pressed, the fan speed is
changed in sequence: (Low)
→ → → → → (Med.) → → → → → (High)
→ → → → → (AUTO)
• Use the (High) notch to cool/heat the room more.
• If the operating sound of the air conditioner disturbs your
sleep, use the (Low) notch.
■
To change the AIR FLOW blowing direc-
tion vertically, press the
VANE button.
Each time the button is pressed, the angle of the
HORIZONTAL VANE is changed in sequence: (1)
→ → → → →
(2) → → → → → (3) → → → → → (4) → → → → → (5) → → → → → (SWING) → → → → → (AUTO)
SWING OPERATION
Use the swing operation for the air flow to reach all cor-
ners of the room.
Recommended HORIZONTAL
VANE range
Use the (AUTO) position usu-
ally.
Use position (1) or (2) in the
COOL or DRY mode and use posi-
tions (3) to (5) in the HEAT mode
when adjusting to your require-
ments.
NOTE
■ In the cooling operation, when the air conditioner is op-
erated with setting the HORIZONTAL VANE to (4) or
(5) for 1 hour, the AIR FLOW direction is automatically
set to horizontal to prevent condensed water from drop-
ping.
■ Adjust the vertical AIR FLOW direction using the remote
controller. If the HORIZONTAL VANE is moved manually,
it may cause trouble.
■ In the heating operation, if the air flow temperature is
too low or when defrosting is being done, the HORIZON-
TAL VANE position is set to (1).
Auto air flow direction control operation
■ When the AUTO mode is selected with the VANE button, the position of the HORIZONTAL VANE is automatically
set to correspond to the operation mode for effective operation.
(2) COOL, DRY
The air is blown out horizontally. When the air flow temperature rises,
the air is blown out downwards.
(1) HEAT
When the air flow temperature is
too low, the air is blown out hori-
zontally.
■
To change the AIR FLOW blowing direction horizontally, press the WIDE VANE button.
Each time the button is pressed, the angle of the VERTICAL VANE is changed in sequence:
→ → → → → → → → → → → → → → → → → → → → (SWING) → → → → → → → → → →
SWING OPERATION
Use the swing operation for the air flow to reach all corners of the room.
About 100 °
COOL/DRY
About 150 °
HEAT
Horizontal AIR FLOW blowing range
NOTE
Adjust the horizontal AIR FLOW direction using the remote controller. If the VERTICAL VANE is moved manu-
ally, it may cause trouble.