MITSUBISHI ELECTRIC MSH24WN - Manual (Page 10)

10
ON/OFF
FAN
TOO
WARM
TOO
COOL
VANE
MODE
STOP
START
HR.
MIN.
I FEEL COOL
DRY
AM PM
CLOCK
˚C
AMPM
WIDE VANE
LONG
HEAT
RESET CLOCK
ON/OFF
FAN
TOO
WARM
TOO
COOL
VANE
MODE
STOP
START
HR.
MIN.
I FEEL COOL
DRY
AM PM
CLOCK
˚C
˚F
AMPM
WIDE VANE
LONG
HEAT
RESET CLOCK
TIMER OPERATION (ON/OFF TIMER)
It is convenient to set the timer when you go to
bed, when you get home, when you get up, etc.
How to set the ON timer
1 Press the START button during operation.
Each time the button is pressed, the ON timer mode
alternates between ON and OFF.
2 Set the time of the timer using the HR.
and MIN. buttons.
Each time the HR. button is pressed, the set time in-
creases by 1 hour; each time the MIN. button is
pressed, the set time increases by 10 minutes.
To release the ON timer:
■
Press the START button.
How to set the OFF timer
1 Press the STOP button during operation.
Each time the button is pressed, the OFF timer mode
alternates between ON and OFF.
2 Set the time of the timer using the HR.
and MIN. buttons.
Each time the HR. button is pressed, the set time in-
creases by 1 hour; each time the MIN. button is
pressed, the set time increases by 10 minutes.
To release the OFF timer:
■
Press the STOP button.
Programming timer operation
The ON timer and the OFF timer can be used in combination.
The timer of the set time that is reached first will operate first.
(“ ” mark indicates the order of timer operations.)
■ If the current time has not been set, the timer operation can-
not be used.
TIMER
NOTE
If the main power is turned off or a power failure occurs
while AUTO START/STOP timer is active, the timer setting
is cancelled. As this model is equipped with an auto restart
function, the air conditioner should start operating at the
same time that power is restored.
LONG OPERATION
Use this operation when you want the air flow to
reach a long distance.
Perform the following operations while the
unit is operating.
■
Press the LONG button.
The fan speed increases.
When the fan speed is set to
(AUTO), the fan speed
is higher than a fan speed determined by the room
temperature and the set temperature.
In addition, the HORIZONTAL VANE moves to the po-
sition for LONG mode.
Mechanism of the LONG operation
In the following example, the VERTICAL VANE is set to
(front).
COOL/DRY HEAT
Fan speed: Higher
Solid arrow: When the LONG mode is used
Dotted arrow: When the LONG mode is not used
To release the LONG mode:
■
Press the LONG button again.
■ LONG mode is also released by pressing the VANE button.
■ Even when the LONG mode is being used, the air may not
reach a long distance due to the installation location of the
air conditioner.
In this case, press the FAN button to set the fan speed to
(High), and then press the LONG button.
■ MODE , FAN , and WIDE VANE buttons, temperature buttons and the ON/
OFF timer (explained on the right) are available.