Connecting an antenna to a cable box or vcr, Cable box, Antenna or wall outlet cable – MITSUBISHI ELECTRIC ws-55413 User Manual

Page 15

Figure 3. Connecting the cable box that does not have

audio or video outputs.

Note: See page 5 for Outdoor Antenna Grounding

Cable Box

(Figure 3)

1. Connect the incoming cable to ANT-A on the

TV back panel.

Connect two coaxial cables as follows:

2. One from LOOP-OUT on the TV back panel to IN

on the cable box back panel.

3. One from OUT on the cable box back panel to

ANT-B on the TV back panel.

NOTE:

If your cable box has separate audio/video

outputs, please see Composite Video with

Audio or S-Video with Audio, page 16

(Figure 6).

Note:

If you have a digital cable box, refer to your

Digital Cable Box owner’s guide for instructions on

optimal connections to this TV.

��

�

��

� � ��

��

Antenna or Wall Outlet Cable

(Figure 4)

1. Connect the incoming cable to ANT-A on the TV

back panel.

Connect two coaxial cables as follows:

2. One from LOOP-OUT on the TV back panel to

ANTENNA IN on the VCR back panel.

3. One from VCR back panel ANTENNA OUT to

ANT-B on the TV back panel.

NOTE:

If your cable box has separate audio/video

outputs, please see Composite Video with

Audio or S-Video with Audio, page 16

(Figure 6).

Note: The TV back panel and connections shown here are for reference only and may vary by model.

��

� � ��

��

�

��

�

Figure 4. Connecting the VCR with antennas or wall

outlet table.

Connecting an Antenna to a Cable Box or VCR

Note:

For models WS-, WS- and WS-,

when the Energy Mode is set to Low, the VCR may not

record programs when the TV is off.

This manual is related to the following products:

ws-48413