Meridian America 504 - Manual (Page 25)

Setting up the FM tuner
21
This is the unit that will respond to the remote.
All the other units will be configured
as non-controllers, and display:
N.Con.
Your system is now set up and ready for use.
● If for any reason the automatic setup does not give the
configuration you want, restore the default operation by
selecting Type 1 as described in To connect to Meridian 600
or 200 Series equipment, opposite.
● If you want to change the automatic setup configuration refer
to the Meridian 500 Series User Guide.
Note: Do not, under any circumstances, connect any equipment
other than Meridian 500, 600, or 200 Series to the socket
marked COMMS on the back of the FM tuner.
To connect to Meridian 600 or 200
Series equipment
If your system includes any Meridian 600 or 200 Series units,
with 600 COMMS or 200 COMMS sockets, you should set all
the 500 Series units to 200 COMMS operation using the
following procedure:
● Turn off the FM tuner, using the power switch on the back
panel.
● Turn on the power again while holding down the Off key on
the front panel.
The display will show the current
setup:
Type 1
Press ] (Next) on the front panel
to change to Type 2:
Type 2
● Switch the power off and on again to restore the FM tuner to
normal operation.
● To return to 500 COMMS operation repeat the above
procedure, and select Type 1.