Meridian America 504 - Manual (Page 24)

Setting up the FM tuner
20
To connect to a conventional
preamplifier
● Connect the sockets marked OUTPUT L and R on the back
panel of the FM tuner to an appropriate input on your
preamplifier.
You should consult the manufacturer’s manual to determine
which input to use, but it will generally be labelled TUNER,
RADIO, or AUX.
You should either use a twin-screened audio cable, or a pair of
single-screened audio cables. These cables can have a
considerable effect on the quality of the sound, and you are
advised to seek your dealer’s advice on the best type of cables
for your system.
To connect to other Meridian 500
Series equipment
● Connect one of the COMMS sockets on the back panel of the
FM tuner to one of the COMMS socket on another 500 Series
unit, using the 500 comms lead provided.
The sequence in which you connect the units is not important.
COMMS COMMS
Then configure the units with the following automatic setup
procedure:
● Switch all the units to standby.
● Press Clear on the remote.
Each unit will display:
Auto
One unit will then be designated as
the controller, and display:
Con.