Multi-Tech Systems MTA128ST-USB - Manual (Page 29)

29
Chapter 4 - AT Commands, S-Registers and Result Codes
MTA128ST-USB
AT Commands by Function
Command Implementation
AT Attention code
Return Command execution
+++AT In-band escape code
AT Out-of-band escape code
Switch Configuration
%A97 Dialing method
!C0 Switch type
!C6 Data SPID
*!C6 Voice SPID
!D3 SAPI-0 data TEI
*!D3 SAPI-0 voice TEI
!L List DN, SPID, TEI, Data protocol & switch type
>Dn Embedded Protocol Analyzer
!N1 Data DN/MSN 1
!N2 Data DN/MSN 2
*!N1 Voice DN/MSN
!RXG Receive gain
!TXG Transmit gain
!Z=n Rate adaptation protocol
USB Port Configuration
En
Command mode echo
L List telephone numbers
L5 List current operating parameters
L6 List S-register values
L8 Display ISDN status
Qn Status displays
Sr=n Set S-register
Sr? Read S-register
Vn Terse/verbose result codes
Xn Connect messages
Zn Restore parameters to current power-up profile
&Cn DCD (Data Carrier Detect) control
&Dn DTR (Data Terminal Ready) control
&En Flow control
#Xn Send Single Multiple Xoff Characters
&Fn Load quick setup factory profile
&Mn Asynchronous/Synchronous mode
&Rn CTS (Clear To Send) control
&Sn DSR (Data Set Ready) control
&Wn Store active profile
&Zn= Store telephone number
&Jn Automatic Channel Bundling
$Dn Persistent DTR dialing
%En Escape sequence options