Multitech PROXYSERVER MTPSR1-120 - Manual (Page 44)

44
Dual Ethernet ProxyServer User Guide
LAN-Based Remote Configuration Procedure
Windows Sockets Compliant TCP/IP Stack
The configuration program requires a Windows Sockets compliant TCP/IP stack. TCP/IP protocol
software must be installed and functional before the configuration program can be used.
1 You must assign an Internet (IP) address for the PC and for each node that will be
managed by the configuration program. Refer to the protocol software documentation for
instructions on how to set the IP addresses.
Once you have completed this step, you should be able to use the protocol Ping
command for the PC host name. You should also test the network interface configuration
by Pinging another TCP/IP device that is connected to the network.
2 Install the Proxy Server software on the local PC. When installed click Start | Programs
| Firewall | Configuration Port Setup, or double click on the Configuration Port Setup
icon in the Firewall program group.
3 The Firewall Setup dialog box is displayed.
Verify that the Communication Type field is set IP.
In the Router IP Address field, enter the IP Address of the remote ProxyServer.
4 Click OK when you are satisfied with your selections.
5 Run the Proxy Server Configuration program. Click Start | Programs | Firewall |
Firewall Configuration, or double click on the Firewall Configuration icon in the
Firewall program group.