Miller Electric XMS 44 - Manual (Page 14)

OM-223 839 Page 10
3-8. Changing Cable Between Wire Feeder and XMS 4000
Y Disconnect power before
changing cables.
1 Access Door
2 Clamp
3 Plastic Collar
Connect weld cable to terminals be-
hind access door.
Remove screws securing door,
clamp and collar. Make cable con-
nections. Reinstall clamp, collar,
and door.
3
3
2
1
Tools Needed:
3-9. Installing Wheels On Wire Feeder (Optional)
1 Wheels
2 Bars
3 Screws
Remove rubber feet from wire feeder.
Install only wheels on feeder if smaller
dimensions are desired, unit will be
used on level floors, or if optional turn-
table is used.
Install wheels and bars for increased
stability on uneven floors.
1
3
1
Tools Needed: