Iso/iec g – Meyer Sound M3D User Manual

Page 2

ECLARATION

ONFORMITY

CCORDING

ISO/IEC G

UIDE

AND

EN 45014

The Manufacturer:
Meyer Sound Laboratories, Inc.
2832 San Pablo Avenue
Berkeley, California 94702-2204, USA

Declares that the product: M3D™, M3D-Sub

Conforms to the following Product Specifications
Safety:

EN60065: 1998
IEC60065: 1998

EMC:

EN55103-1: 1997 emission(1)
EN55103-2: 1997 immunity(2)

This device complies with the requirements of the Low Voltage
Directive 73 / 23 / EEC and the EMC Directive 89 /336 / EEC.

This device also complies with EN 55103-1 & -2. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including

interference that may cause undesired operation.

Environmental Specifications For Meyer Sound Electronics
Products:

Operating Temperature

0˚C to + 45˚C

Nonoperating Temperature

<-40˚C or > +75˚C

Humidity

to 95% at 35˚C

Operating Altitude

to 4600 m (15,000 ft)

Nonoperating Altitude

to 6300 m (25,000 ft)

Shock

30g 11 msec half-sine on each
of 6 sides

Vibration

10Hz to 55Hz (0.010m
peak-to-peak excursion)

OPYRIGHT

M3D Line Array Loudspeaker Operating Instructions.

The contents of this manual are furnished for informational purposes only, are subject to change without notice, and should not be

construed as a commitment by Meyer Sound Laboratories, Inc. Meyer Sound assumes no responsibility or liability for any errors or

inaccuracies that may appear in this manual.

Except as permitted by applicable copyright law, no part of this publication may be reproduced, stored in a retrieval system, or

transmitted, in any form or by any means, electronic, mechanical, recording or otherwise, without prior written permission from Meyer

Sound.

M3D™, TruPower™, RMS™, BroadbandQ™, MAPP Online™ and REM™ are trademarks of Meyer Sound. SIM

and QuickFly

are registered

trademarks of Meyer Sound (Reg. U.S. Pat. & Tm. Off.). All third-party trademarks mentioned herein are the property of their respective

trademark holders.

Printed in the U.S.A.

Part Number: 05.105.022.01 Rev. A (08/02)

Office of Quality Manager
Berkeley, California USA July 19, 2002

European Office:
Meyer Sound Lab. GmbH
Carl Zeiss Strasse 13
56751 Polch, Germany

Made by Meyer Sound Laboratories
Berkeley, California USA

3K59 COMMERCIAL

AUDIO SYSTEM