Motorola D1010 - Manual (Page 28)

28 Using your Answer machine
Remote access
Remote access allows you to operate your answer machine and listen to
your messages by calling your D1011 from another phone.
The default setting is on.
1. Call your D1011. When you hear your outgoing message, press #.
2. Enter your 4 digit PIN. The default code is
0000 .
- You hear a confirmation beep.
NOTE
Change this code for increased security, see “PIN” on page 24.
3. After entering your PIN as stated above, use the keypad to operate
your D1011 answer machine:
Remote Access on/off
1. Press
m
, scroll
d
to ANSW MACHINE and press
m
.
2. Scroll
d
to ANSW SETTINGS and press
m
.
3. Scroll
d
to REMOTE ACC and press
m
.
4. Scroll
u
or
d
to select ACTIVATED or DEACTIVATED .
5. Press
m
to confirm.
Call screening
Use your handset or base speaker to hear a caller leaving a message.
You can then choose to ignore the caller or pick up the call.
The default settings are:
• Handset call screening: Off
• Base call screening: On.
At the handset:
1. If you want to interrupt and take the call press
<
or
v
At the base:
1. When a caller is leaving a message, press
+
or
-
to adjust the
volume to listen to your caller.
2. To interrupt and take the call on the handset, press
<
or
v
.
Switch handset call screening on/off
1. Press
m
, scroll
u
or
d
to ANSW MACHINE and press
m
.
2. Scroll
d
to ANSW SETTINGS and press
m
.
3. Scroll to HS SCREENING and press
m
.
4. Scroll
u
or
d
to select ON or OFF .
5. Press
m
to confirm.
Switch base station call screening on/off
1. Press
m
, scroll
d
to ANSW MACHINE and press
m
.
2. Scroll
d
to ANSW SETTINGS and press
m
.
3. Scroll
d
to BS SCREENING and press
m
.
4. Press
u
or
d
to select ON or OFF .
5. Press
m
to confirm.
Answer Machine language
You can change the language of the pre-recorded outgoing messages.
1. Press
m
. Scroll
u
or
d
to ANSW MACHINE and press
m
.
2. Scroll
d
to ANSW SETTINGS and press
m
.
3. Scroll to TAM LANGUAGE and press
m
.
4. Scroll
u
or
d
to select the language.
5. Press
m
to confirm.
Access answer machine menu via the Calls list
When the is flashing to indicate new messages you can see caller
details via
u
or press
d
again to go to ANSW MACHINE to play new
messages.
1. Press
u
, CALL LIST is displayed.
2. Press
d
, ANSW MACHINE is displayed.
Play messages 2
Play previous message 1
Play next message 3
Delete message playing 6
Switch answer machine on 7
Stop playback 8
Switch answer machine off 9