Mantis Pruner E System - Manual (Page 10)

9
Area Maintenance procedure Frequency
Oiling port
Inspect/clean
Before each use
Nose sprocket
Clean/lubricate Before each use
Saw chain Inspect/clean/sharpen/lubricate/replace Before each use
Screws/nuts/bolts Inspect/tighten/replace Before each use
Service maintenance guide
Oiling port
Grease port of the nose
sprocket
Area Maintenance Before Every 25 Every 50 Every 100 Note
use hours hours hours
Cutting Parts Replace if
✔
something is wrong
Screws, nuts Tighten, replace
✔ ✔
Not adjusting
bolts screws
IMPORTANT: Time intervals shown are maximum. Actual use and your experience will determine the frequency of
required maintenance.