Nesco LD 500/500V 15" - Manual (Page 4)

LD 500/500V User Manual
Safety Precautions
Please read following instructions before use:
1. Do not apply pressure to the LCD screen. Excess pressure may cause permanent
damage to the display.
2. Do not scratch or press on the panel with any sharp objects, such as a pen or pencil, as
this may result in damage to the panel.
3. Store the LCD monitor at a temperature of –20 °C ~ 60°C (or –4° ~ 140°F).
4. Avoid exposing the monitor to direct sunlight and ensure the area around the monitor
is free from moisture. Never allow any liquid to get inside the monitor.
5. Do not place any objects on the case.
6. Never place the monitor near a heat source such as a radiator.
7. Do not open the case of the monitor, as doing so may expose you to dangerously high
voltage levels. Never attempt to perform repairs on the monitor yourself, but refer all
servicing to qualified personnel.
8. Disconnect the monitor from the power outlet when the monitor is not in use for
extended periods of time.
9. To increase the life of the LCD Panel, make sure to turn off the power or reduce its
brightness when the monitor is not in use.
10. The monitor is equipped with a three-wire grounding-type plug. For safety, this device
should only be used with a grounding-type power outlet. If your outlet is not of this
type, contact your electrician for replacement. Never use a 3-to-2 prong adapter.
Safety requirements may differ. Please select a suitable power cord depending on the
particular area where you are located:
A. North America: Please select a UL listed and CSA certified power cord.
B. Germany: Please select VDE certified power cord.
C. Nordic countries: Please select a power cord certified by SEMKO, NEMKO,
DEMKO or FEMKO
D. Other areas: Please select a power cord suitable to the local power system and
power outlet.
Usually when this product is sold, a suitable power cord is provided by the
manufacturer. However, this product may sometimes be resold or transported to
another area with a different power system and safety requirements. Please pay
attention to the selection of a suitable power cord.
The plug on the power cord is intended to serve as the disconnect device, the
socket-outlet shall be installed near the equipment and shall be easily accessible.
11. This monitor can only be connected to the following adapter:
Brand: LINEARITY Type: LAD6019AB4
Brand: LIEN CHANG Type: LCA01F
12. This monitor is designed with a universal power supply that accommodates 100 – 240
VAC and frequency of 50 – 60Hz.
- 4 -