beautypg.com

Troubleshooting – Nesco LD 500/500V 15" User Manual

Page 16

background image

LD 500/500V User Manual

Troubleshooting

This LCD monitor has been pre-configured using factory standard VGA timings. Due to the
output timing differences among various VGA cards in the market, users may initially
experience an unstable or unclear display whenever a new display mode or new VGA card is
selected.

Important:
This LCD monitor supports multiple VGA modes.
Refer to the standard Timing Table for a listing of modes supported by this LCD monitor.

Problem

Points to check with possible solutions

No power

Make sure the power button is ON
Make sure the power cord is firmly connected to the back

of the monitor and to a power outlet.

Power on but no screen
image

Make sure the signal cable supplied with the monitor is

fully inserted into the video output port on the back of the
computer. If the other end of the signal cable is not
attached permanently to the monitor, tightly secure it to
the

monitor.

Adjust brightness and contrast.

No signal Input

Check that the PC is turned ON
Check that the signal cable is properly connected to the

graphics board or PC.

Check that the graphics board is correctly inserted in the

PC.

Out of range error
message appears

Use the graphics board’s utility software to change the

frequency setting. (Refer to the manual for the graphics
board.)

For Windows 95 users (OSR 2.0 or newer) or Windows 98,

restart the PC in a safe mode and change the frequency in
the “Display” setting for the PC.

Vertical bars of distortion
appear

Make adjustments to the “Image”, “Clock” setting in the

OSD

menu.

Horizontal bars of
distortion appear.

Make adjustments to the “Image”, “Phase” setting in the

OSD

menu.

The screen has defective
pixels (e.g. slightly light or
dark)

This is due to the characteristics of the panel itself, not

the LCD monitor.

Incorrect display of colors

If any colors (red, green, or blue) are missing, check that

the signal cable is firmly connected. Damaged pins in the
cable connector may also result in a faulty connection.

- 16 -