Marley Engineered Products C1800 - Manual

Electric Baseboard Heaters
1800, 2500, C1800 & C2500 Series
WARNING
Installation & Maintenance Instructions
Dear Owner,
Congratulations! Thank you for purchasing this new heater manufactured by a division of Marley
Engineered Products. You have made a wise investment selecting the highest quality product in the heat-
ing industry. Please carefully read the installation and maintenance instructions shown in this manual.
You should enjoy years of efficient heating comfort with this product from Marley Engineered Products...
the industry’s leader in design, manufacturing, quality and service.
... The Employees of
Marley Engineered Products
Read Carefully - This Instruction Sheet contains vital
information for the proper installation, use, and efficient
operation of the heater. Carefully read the manual before
installation, operation, or cleaning of the heater. Failure to
adhere to the instructions could result in fire, electric
shock, death, serious personal injury, or property damage.
Save these instructions and review frequently for continu-
ing safe operation and instructing future users.
1. Keep all electrical cords, foam filled articles, drapes, bed-
ding, and other household furnishings away from contact with
heater. It is recommended all items be kept a minimum of
six (6") inches (152mm) from heater.
2. Do not install baseboard heater below electrical convenience
receptacles (outlets).
3. Do not install baseboard heater against vinyl wallpaper,
paperboard or low density fiberboard surface. Do not install
vinyl drapes or vinyl blinds above heater.
4. Do not recess heater in wall.
5. The installation must comply with applicable Local and National
Electrical Codes and utility requirements.
6. Do not remove or by-pass thermal cutout.
7. To reduce the risk of fire, do not store or use gasoline or
other flammable vapors and liquids in the vicinity of the
heater.
8. Personal injury or death could result from electric shock.
Disconnect all power to heater at main panel before attempting
to install or service this heater.
9. Supply voltage must be the same as heater voltage. Check
heater nameplate and supply voltage before energizing.
10. When using RSA Transformer Relay Accessory, supply
wiring must be suitable for 90°C.
!
1
File #E37116