Mazda 2006 3 4-DOOR - Manual (Page 284)

Black plate (284,1)
6. Replace the bulb.
7. Install the new bulb in the reverse order
of removal.
NOTE
l To replace the bulb, contact an
Authorized Mazda Dealer.
l If the halogen bulb is accidentally
touched, it should be cleaned with
rubbing alcohol before being used.
l Use the protective cover and carton
for the replacement bulb to dispose
of the old bulb promptly and out of
the reach of children.
l When reinstalling the sealing cover,
make sure
faces up.
Replacing a fog light bulb
í
1. Turn the screw counterclockwise and
remove it and partially peel back the
mudguard.
2. Turn the socket and bulb assembly
counterclockwise and remove it.
Carefully remove the fog light bulb
from its socket in the reflector by
gently pulling it straight backward out
of the socket.
3. Disconnect the bulb from the electrical
connector by pressing the tab on the
connector with your finger and pulling
the bulb upward.
4. Install the new bulb in the reverse order
of removal.
NOTE
l To replace the bulb, contact an
Authorized Mazda Dealer.
l If the halogen bulb is accidentally
touched, it should be cleaned with
rubbing alcohol before being used.
l Use the protective cover and carton
for the replacement bulb to dispose
of the old bulb promptly and out of
the reach of children.
Front turn signal lights/Side-marker
lights
Due to the complexity and difficulty of
the procedure, the bulbs should be
replaced by an Authorized Mazda Dealer.
Side turn signal lights
1. Slide the unit as shown in the figure to
remove it.
8-38
Maintenance and Care
í
Some models.
Owner Maintenance
Mazda3_8U55-EA-05G_Edition1 Page284
Tuesday, May 31 2005 1:20 PM
Form No.8U55-EA-05G