Miller Electric DVI-2 R - Manual (Page 32)

.
A complete Parts List is available at www.MillerWelds.com
OM-232 386 Page 28
Wire Drive/Gun Trouble Remedy
Electrode wire feeding stops during
welding. Straighten gun cable and/or replace damaged parts (see welding gun Owner’s Manual).
welding.
Adjust drive roll pressure (see Section 4-13).
Readjust hub tension (see Section 4-8).
Replace contact tip if blocked (see welding gun Owner’s Manual).
Clean or replace wire inlet guide or liner if dirty or plugged (see welding gun Owner’s Manual).
Replace drive roll if worn or slipping (see Section 6-3).
Check and clear any restrictions at drive assembly (see Section 6-3).
Have nearest Factory Authorized Service Agent check drive motor.