Metra Electronics 99-7878B - Manual (Page 8)

99-7878B KIT ASSEMBLY
DOUBLE DIN/STACKED ISO MOUNT
UNITS RADIO PROVISION
Locate the factory wiring harness in
the dash. Metra recommends using
the proper mating adapter from Metra
or AXXESS. Re-connect the negative
battery terminal and test the unit for
proper operation. 1
Cut and remove the center bar from
the radio housing. (Figure A) 2
Snap the Double DIN brackets to the
inside edge of the Double DIN trim
plate. (Figure B) 3
Slide the Double DIN head unit or
stacked ISO head units into the
bracket/radio housing assembly and
secure the Double DIN head unit or
stacked ISO head units to the
assembly using the screws supplied
with the radio. (Figure C) 4
* Note: Refer also to the instructions included with the aftermarket radio.
A
B
C
Reassemble dash in reverse order of
disassembly. 6
Snap the Double DIN trim plate into the
Radio Housing. (Figure C) 5
1-800-221-0932
REV. 07/15/09 © COPYRIGHT 2009 METRA ELECTRONICS CORPORATION INST99-7878B
www.metraonline.com