Maytag W10099060 User Manual

Page 14

5. Lift the inner door assembly off of the outer door assembly.

Unsnap the handle from the outer door assembly, move it to
the other side, and snap in. Set the outer door assembly
aside.

Reverse the hinge and hinge bracket

1. Place the inner door, screw head side up, on the work

surface.

2. Remove the 4 screws that hold the hinge to the door.

3. Remove the 2 screws that hold the handle bracket to the

door.

4. Move hinge to the other side and reattach with the 4 screws

removed in Step 2.

5. Move handle bracket to the other side and reattach with the

2 screws removed in Step 3.

6. Set the inner door assembly aside.

Reinstalling the door

1. Check for fingerprints on the glass. Clean if necessary.

2. Place the inner door assembly into the outer door assembly.

Align the hinge in the opening on the side. To fit correctly, the
inside door assembly edge is completely inside the outside
door assembly edge.

3. Reassemble the inner and outer door assemblies with the

6 screws.

4. Replace the 2 handle screws for the door handle of the door

assembly.

5. Remove the plug strip or label.

Style 1: Remove the plug strip.

■

Use a small flat-blade screwdriver to remove the plug
strip in the door opening. Slide the head of the
screwdriver under the top portion of the plug strip, being
certain not to scratch the dryer surface. Lift up. Repeat in
the middle and at the bottom. Remove the plug strip in
the door opening and insert in the opposite side.

Style 2: Remove the label.

■

Peel off the label located on the opposite side of the door
opening covering the hinge mounting holes. Apply the
label over the original hinge holes.

6. Insert a screw in the second opening from the top of the

hinge opening and partially tighten. Hang the door by placing
the top hinge keyhole over the second screw head and
tighten the screw. By putting this screw in first, the door will
hang in place while you insert and tighten the remaining
4 screws.

7. Close the door and check that it latches securely.

A. Dryer door
B. Dryer

C. Insert this screw first.