Testing the connections – Motorola SBV6120E User Manual

Page 17

3 Installing the Digital Voice Modem

POWER

Testing the Connections

To verify that all the components were properly installed, perform the following connectivity test:

1. Power on your computer.

2. Check the LEDs on the SBV6120 front panel.

The TEL 1 and TEL 2 LEDs should be on, if the SBV6120 was provisioned for voice
service. Otherwise, TEL 1 and TEL 2 will be off.

The remaining LEDs should be on or flashing.

Note: Refer to

for LED status information.

3. Open a web browser.

4. Go to any website to check for an Internet connection.

5. Check the telephone for a dial tone. If there is no dial tone, then your telephone line is not

set up for voice service.

Note

: Contact your service provider to provision the telephony line(s).

If the connectivity test failed, see

for a possible solution.

You may now wall mount your SBV6120 digital voice modem. See

for more information.