MITSUBISHI ELECTRIC WD-62525 - Manual (Page 93)

92 93
IMPORTANT
For further assistance, call
(800) 332-2119.
Appendix G: Diamond Shield™ Removal
The Diamond Shield is installed by the factory to
enhance your television viewing experience. If you
want to remove the Diamond Shield, please follow
the steps listed below:
To Remove the Diamond Shield:
1. While wearing soft cotton gloves, loosen the
sides of the Diamond Shield by pressing a small
plastic card (the size of a standard credit card or a
clean, plastic, putty knife) into the middle of the
side slot. The Diamond Shield side will snap out
of the top middle and bottom clips. Loosen both
sides before proceeding to step 2.
2. After the sides are free, gently push down on the
top of the Diamond Shield. It will slide out of the
top channel.
3 Carefully pull the screen up to remove it from the
bottom channel. Store the Diamond Shield in a clean,
dust free area, where it will not be scratched.
To Install the Diamond Shield:
4. Slide the Diamond Shield into the bottom channel,
making sure it fits securely.
5. Press gently on the top of the Diamond Shield to
slightly bow the screen towards you. Insert the
top of the Diamond Shield into the top channel. It
should fit securely.
6. At each side, gently press the top, middle and
bottom of the Diamond Shield to snap it back into
place.
.
WARNING
Sharp edges! Always wear gloves to
handle, lift, install and remove the
Diamond Shield.
1b
1a
1 1
2
3
6
6
5
4
6
6
6
6
1
1
1
1