MITSUBISHI ELECTRIC WD-62525 - Manual (Page 25)

24 25
Connecting a DTV Receiver with RGB, HV Video
DTV Receiver with RGB, HV Video
Figure 13
A coaxial splitter, RGB, HV and audio cables are required.
These are not included with the TV.
1. Connect the outside antenna, cable or satellite to
ANT or SATELLITE IN on the DTV receiver (see your
DTV receiver owner’s guide for instructions and
cable compatibility).
2. Connect the incoming terrestrial antenna or cable
(not satellite) to ANT-1 on the TV back panel
(a coaxial splitter, available at most electronic
supply stores, may be required to complete this
installation).
3. Connect RGB cables from the DTV receiver to Input-
DTV on the TV back panel.
DTV Receiver to TV Back Panel
• G (green) to Y/G
• R (red) to Pr/R
• B (blue) to Pb/B
4. Connect the H & V sync signals as shown below:
• H (horizontal sync) to H
• V (vertical sync) to V
All 5 cables (G,R,B,H and V) must be connected. 3 cables
or Sync on green connections are incomplete or not
compatible and will not work.
5. Connect the L (left) and R (right) audio cables from
the DTV Receiver to Input-DTV AUDIO on the TV
back panel.
See Appendix B for RGB, HV video signal
compatibility information.
For digital audio connections, see your
DTV Receiver and A/V receiver Owner’s
Guides.
IMPORTANT
IR EMITTER
NetCommand R
INPUT-1
AUDIO 2
AUDIO/VIDEO 1
AUDIO
L(MONO) R
INPUT-2
COMPONENT-1 YPbPr (480i/480p/720p/1080i)
Y/G Pb/B Pr/R
COMPONENT-2
YPbPr (480i/480p/720p/1080i)
INPUT-DTV
YPbPr / RGB HV (480i/480p/720p/1080i)
DTV/ CABLE/ VHF/
UHF
ANT-2 AUX
ANT-1 MAIN
DIGITAL AUDIO
PC VGA/SVGA/XGA/ 720p
60 Hz
PC-
AUDIO
PC- INPUT
M-LINK CONTROL/ RS-232C
HDMI
M-LINK
IEEE1394 INPUT/OUTPUT
VIDEO S-VIDEO MONITOR OUTPUT
L
R
V H
CARD TOP
C ab leC
AR D
SL O T
TM
DTV Receiver
(with RGB connections)
G R B
S-VIDEO
VCR
CONTROL
PHONE JACK
RF
REMOTE
OUT TO TV
CH 3
CH 4
CAUTION
RISK OF ELECTRICAL SHOCK DO NOT OPEN
DIGITAL
AUDIO OUT
White
Red
Incoming
Antenna
or Cable
SATELLITE IN IN FROM ANT
or
to antenna,
cable or satellite
AUDIO
L
R
H
V
1.
1.
4.
4.
5.
4.
5.
3.
3.
2.
2.
TV back panel
DVI Analog Audio L
R
AUDIO
L(MONO) R
White
Red
w
h
i
t
e
R
e
d
Figure 13. Connecting an External DTV Receiver with
RGB Video Connections
It may be necessary to obtain a VGA to RGB,
HV adaptor cable. These are available at
most computer stores and many electronic
stores. Some of the adaptor cables have
RCA type connector ends, others have BNC
type ends and will require adaptors as shown
on page 24.