Miele KFN 9753 iD EN - Manual (Page 48)

Installing the appliance
– For 16 mm cabinetry walls:
The spacers lie flush on the upper
and lower front edge of the cabinetry
side wall
a.
– For 19 mm cabinetry walls:
The front edges of the hinges above
and below are flush with the front
edge of the cabinetry side wall
b.
^ Check again to see whether the
covers on the upper and lower
mounting brackets are lying on the
front edge of the cabinetry side wall
d.
This will help to maintain a 42 mm
distance all the way around from the
front edges of the cabinetry side walls.
For furniture with parts along the
door hinge (such as nubs, seals, etc.)
the installed dimensions of the hinge
parts must be taken into account, so
that a distance of 42 mm is maintained
all the way around.
^ Pull the appliance forward the
appropriate amount to suit the
installed dimensions.
The hinges and covers will now be
positioned to suit the dimensions.
Tip: Remove the door hinge parts. This
will allow the surrounding cabinetry
doors to lie flush.
If a circumferential distance of 42
mm (from the body of the appliance
to the front side of the cabinetry side
wall) is not maintained, the
appliance door may not close
properly.
This can cause icing, condensation
and malfunctions.
^ Use the fork wrench to adjust the feet
as needed, so that the appliance is
level
c.
Installing the appliance
48