Mercury Sable 1999 - Manual (Page 83)

Safety belt maintenance
Inspect the safety belt systems periodically to make
sure they work properly and are not damaged.
Inspect the safety belts to make sure there are no
nicks, wears or cuts, replacing if necessary. All
safety belt assemblies, including retractors, buckles,
front seat belt buckle assemblies (slide bar)(if
equipped), shoulder belt height adjusters (if
equipped), child safety seat tether bracket
assemblies (if equipped), and attaching hardware,
should be inspected after a collision. Ford
recommends that all safety belt assemblies used in
vehicles involved in a collision be replaced. However,
if the collision was minor and a qualified technician
finds that the belts do not show damage and
continue to operate properly, they do not need to be
replaced. Safety belt assemblies not in use during a
collision should also be inspected and replaced if
either damage or improper operation is noted.
Failure to inspect and if necessary replace
the safety belt assembly under the above
conditions could result in severe personal injuries
in the event of a collision.
Refer to Cleaning and maintaining the safety
belts in the Maintenance and care section.
AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM
(SRS)
BASS TREB
BAL
FADE
REW FF EJECT
1 2 3 4 5 6 w TAPE SIDE TAPE R-DEF
TUNE
SEEK SCAN
AM FM
M H
LO
HI
OFF A/C MAX
A/C
VENT
VOL PUSH-ON
w ST FM 12
AMC BL RF
E
F
C
H FUEL DOOR>
SERVICE
ENGINE SOON LOW COOLANT THEFT 10 20 30 40 50 60 70 80 90 100
120 20
60 100 140
180 P R N D 2 1 MPH km/h
0
0 0 0 0
0 0 0 0 0
P !
BRAKE
+ –
110 CRUISE
RPMx1000
ABS O/D
OFF REAR
LAMP
OUT PREMIUM UNLEADED
FUEL RECOMMENDED 0
1 2 3 4 5 6 7 8
Seating and safety restraints
83