Monessen Hearth Super B-Vent Gas Fireplace 7000 Series User Manual
Page 19
G
G
A
A
S
S
L
L
I
I
N
N
E
E
A
A
N
N
D
D
E
E
L
L
E
E
C
C
T
T
R
R
I
I
C
C
A
A
L
L
I
I
N
N
S
S
T
T
A
A
L
L
L
L
A
A
T
T
I
I
O
O
N
N
18
Pilot must be lit and the valve control knob turned to the “ON” position. Meter leads must be connected to
the TP and the TH/TP terminals on the control valve.
• Turn RS-ON-OFF switch to the “ON” position.
9 If meter is reading more than 175 millivolt and the main burner does not come on, then replace
control valve.
9 If meter is reading less than 175 millivolt, then refer to TROUBLESHOOTING section of this
manual to determine the cause of the low reading.
• Turn RS-ON-OFF switch to the “RS ” position and wall switch to “ON”
9 If meter is reading more than 175 millivolt and the main burner does not come on, then replace
control valve.
9 If meter is reading less than 175 millivolt, then refer to TROUBLESHOOTING section of this
manual to determine the cause of the low reading.
Electronic Pilot Ignition Wiring:
WARNING
Do not connect 110-120 VAC to the Remote Wall Switch. The appliance will malfunction or be destroyed.
Figure 14: Wiring Diagram for Electronic Ignition System
Remote Wall Switch
Position the wall switch. Refer to Figure 14: Wiring Diagram for Electronic Ignition System. Do not
extend beyond the 15 feet of wire.