Makita AG090 - Manual (Page 12)

12
Loading nailer
CAUTION:
• Be careful not to touch the trigger when loading the nail.
• When loading nail into the nailer, grip the nail by the
shank, not the tip.
Hold the nail shank lightly and insert the nail head into the
nail guide until the nail is held firmly by the magnet.
Adjusting depth of nailing
CAUTION:
• Always disconnect the hose before adjusting the depth
of nailing.
To adjust the depth of nailing, turn the adjuster so that the
arrow above the adjuster will point to the number indicated
on the adjuster. The depth of nailing is the deepest when the
arrow points to the number 1. It will become shallower as the
arrow points to higher number. The depth can be changed in
approx. 1.5 mm (1/16”) increments per graduation. If nails
cannot be driven deep enough even when the arrow points to
the number 1, increase the air pressure.
Connecting air hose
Slip the air socket of the air hose onto the air fitting on the
nailer. Be sure that the air socket locks firmly into position
when installed onto the air fitting. A hose coupling must be
installed on or near the tool in such a way that the pressure
reservoir will discharge at the time the air supply coupling is
disconnected.
Nail head
Nail shank
Nail tip
Nail
Magnet
Nail guide
Contact arm
Adjuster
Air fitting
Air socket