Motorola SBV5120 - Manual (Page 24)

19 SBV5120 Series VoIP Cable Modem User Guide
Home
X
Exit Print
Introduction Installation Troubleshooting Glossary License
When you finish setting up the USB driver, you can continue with “Configuring TCP/IP in Windows XP” on
page 26.
Configuring TCP/IP
The SURFboard VoIP cable modem contains all required software. You do not need to configure the VoIP cable
modem, but you must be sure that your computer is configured for
TCP/IP (a protocol for communication between
computers). Perform one of the following:
•
“Configuring TCP/IP in Windows 95, 98, or Windows Me” on page 20
•
“Configuring TCP/IP in Windows 2000” on page 22
•
“Configuring TCP/IP in Windows XP” on page 26
•
Follow the instructions in your Macintosh or UNIX user manual
After configuring TCP/IP, perform one of the following to verify the IP address :
•
“Verifying the IP Address in Windows 95, Windows 98, or Windows Me” on page 29
•
“Verifying the IP Address in Windows 2000 or Windows XP” on page 30
•
Follow the instructions in your Macintosh or UNIX user manual
Your cable service provider may provide additional instructions to set up your computer.
Although your SURFboard VoIP cable modem model number
may be different than in the images in this guide, the
procedure is the same.