MITSUBISHI ELECTRIC HS-U748 - Manual (Page 24)

22
IMPORTANT
For the best quality recording, use S-VHS tapes and
record in the S-VHS format.
The quality of S-VHS ET recordings will vary by the quality
of VHS tapes used. For the best quality S-VHS ET
recordings, it is recommended that you use HG grade
tapes.
S-VHS recordings can be played on:
• S-VHS VCRs
• VHS VCRs with S-VHS Quasi playback capabilities
S-VHS ET recording can be played on:
• S-VHS VCRs (not all S-VHS VCRs will be able to play
S-VHS ET)
• VHS VCRs with S-VHS Quasi playback capabilities
Please use this VCR or S-VHS VCR with S-VHS ET mode
to playback the tape recorded in S-VHS ET for better
picture quality.
Selecting S-input Setting
To watch the picture from the other equipment that is connected to
the HS-U748 rear panel through the VCR, you have to select the
S-video input jack or video input jack that matches the equipment.
1 Press MENU on the remote control. VCR Main Menu appears.
2 Press the ADJUST buttons on the remote control to select
S-VHS Set-Up. Press ENTER.
3 Press the ADJUST buttons to select Rear S-input.
4 Press ENTER to select which input jack to input.
• select OFF when you want to input signals from video
input jack.
• select ON when you want to input signals from S-video
input jack.
5 Press MENU twice to exit the menus.
Recording
»S-VHS Set-Up
ƒS-VHS Auto record ON OFF
ƒS-ET record Auto ON OFF
ƒRear S-input ON OFF
∫πMENU to go back
∂ ππADJUST to select
≤¥≥πENTER to change
∑ ππADJUST to select